MIL-D-44144A(GL)
3.6.9 Signal device. An audible signal device and visible warning light
shall activate when tested as specified in 4.6.11.
3.7 Marking.
Marking for identification shall be in accordance with
MIL-STD-130.
3.8 Workmanship, The units shall be free from fractures, splits, punctures,
tears, dents, creases, bows, miscasts, deteriorations or malformations. There
shall be no sharp edges, burrs or slivers, The finish shall be free of
blisters, orange peel, color separation, chipped areas or areas of no film. The
finish shall be free from smudges, poor touch up, scale, scratches, stain,
overspray, sag, imprint or embedded foreign matter, Threaded fasteners shall
not be broken, stripped or loose. Holes for rivets shall be accurately punched
or drilled and any burrs that would prevent proper seating of the rivet shall be
removed. Rivets shall completely fill the holes, with full size heads neatly
finished and in full contact with the surface of the riveted members and shall
not be loose.
3.8.1 Welding. The surfaces of parts to be welded shall be free from oxide,
scale, paint, grease, and other foreign matter. Welds shall be continuous,
sound smooth, and free from porosity, cracks, incomplete fusion, and deformation
of material. All scale and flux deposits (when flux is used) shall be removed
from the finished welds, and rough edges and projections shall be dressed
smooth.
3.8.2 Electrical wiring. Wiring shall not be cut, abraded, or have excessive
insulation stripped, and shall be properly and tightly joined at terminals.
Wiring shall have adequate slack to provide strain relief.
3.8.3 Welders. Before assigning any welder to work, the contractor shall
provide the contracting officer, or his authorized representative, with the
names of welders to be employed in the work, together with certification that
each of these welders has passed a qualification test as prescribed by either of
the following listed codes for the type of welding operation to be performed,
and that such qualification is effective as defined by that particular code as
follows:
a.
Standard Qualification Procedure of the American Welding Society.
Welding Qualification of the American Society of Mechanical
b.
Engineers,
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise specified
in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business