MIL-L-44142A(GL)
3.10 Workmanship. The units shall be free from fractures, splits, punctures,
tears, dents, creases, bows, miscasts, deteriorations or malfunctions. There
shall be no sharp edges, burrs or slivers. The finish shall be free of
blisters, peel, chipped areas or areas of no film. The finish shall be free
from smudges, poor touch up, scale, scratches, stain, overspray sag, imprint or
embedded foreign matter. Threaded fasteners shall not be broken, stripped or
loose.
3.10.1 Welding. The surfaces of parts to be welded shall be free from oxide,
scale, paint, grease, and other foreign matter. Welds shall be continuous,
sound, smooth, and free from porosity, cracks, incomplete fusion, and
deformation of material. All scale and flux deposits (when flux is used) shall
be removed from the finished welds, and rough edges and projections shall be
dressed smooth.
3.10.2 Electrical wiring. Wiring shall not be cut, abraded, or have exces-
sive insulation stripped, and shall be properly and tightly joined at terminals.
Wiring shall have adequate slack to provide stain relief.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise specified
in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified
herein, unless disapproved by the Government. The Government reserves the right
to perform any of the inspections set forth in this document where such
inspections are deemed necessary to assure supplies and services conform to
prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of
sections 3 and 5. The inspection set forth in this document shall become a part
of the contractor's overall inspection system or quality program. The absence
of any inspection requirement in the document shall not relieve the contractor
of the responsibility of assuring that all products or supplies submitted to the
Government for acceptance comply with all requirements of the contract.
Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to
acceptance of defective material.
4.1.2 Responsibility for dimensional requirements. Unless otherwise speci-
fied in the contract or purchase order, the contractor is responsible for
assuring that all specified dimensions have been met. When dimensions cannot be
examined on the end item, inspection shall be made at any point or at all points
in the manufacturing process necessary to assure compliance with all dimensional
requirements.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business