OO-W-00860E (GSA-FSS)
3.13.2.2 Outer tub and clothes basket. This washer's outer tub shall
be made of steel with a porcelain enamel finish in accordance with the
requirements of 3.4.1 or a suitable durable plastic. The clothes
basket (inner tub) shall be made of corrosion-resisting steel or steel
with porcelain in accordance with the requirements of 3.4.1.
A corrosion-resisting steel basket is required for Navy procurements.
3.13.2.3 Transmission.
This washer's transmission shall be permanently
lubricated in a sealed casing and designed for self-service, automatic,
continuous duty operation. Gears, if used, shall be flame or case
hardened steel, celcon or sintered iron material.
3.13.2.4 Plumbing requirements. This washer shall be provided with
plumbing in accordance with the requirements of 3.12.
This automatic washing machine
3.13.2.5 Type I. class 4, size 1.
shall have a rated clothes capacity of at least 14 pounds (dry weight).
Unless otherwise specified (see 6.2), this washer shall not require
bolting down or permanent installation. If an unbalanced (load)
condition occurs during the spin or extract phase, this condition shall
be automatically compensated for within the washer or a switch shall be
provided to cutoff the washer so that the operator can correct the
unbalanced condition. This washer shall have overall dimensions of not
more than 45 inches in height, 30 inches in width and 29 inches in
depth.
3.13.2.6 Type I. class 4, size 2. This automatic washing machine
shall be the same as a Type I, class 4, size 1 (see 3.13.2.4) except
that the washer shall have a rated clothes capacity of at least 18
pounds (dry weight).
3.14 Type II drying-tumbler. This drying tumbler shall dry a full
clothes load for a type I, class 3 washer, in the time interval
recommended by the manufacturer and selected by the operator. This
dryer shall shut off automatically when the operation is completed.
This dryer shall have provisions for collecting lint accumulated during
the drying cycle. Means for leveling the machine shall be provided.
3.14.1 Cabinet. This dryer's cabinet shall be made of steel and
finished as specified in 3.4. Height including control panel shall not
exceed 45 inches, the floor surface area covered by the dryer shall not
exceed 900 square inches, and the width shall not exceed 32 inches.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business