MIL-DTL-1407D
2.2.2 Other Government documents, drawings, and publications. The following other Government documents,
drawings, and publications form a part of this document to the extent specified herein. Unless otherwise
specified, the issues of these documents are those cited in the solicitation or contract.
U.S. ARMY NATICK SOLDIER CENTER
Army Drawing 5-7-30
Pin Set, Marking Laundry, Carrier and Tray
Army Drawing 5-7-31
Pin Set, Marking Laundry, Complete with Pins
(Copies of this drawing should be addressed to the U.S. Army Natick Soldier Center, ATTN: AMSRD-NSC-AD-B,
15 Kansas St., Natick, MA 01760 or at https://www.natick.army.mil .)
2.3 Non-Government publications. The following documents form a part of this specification to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or
contract.
AMERICAN SOCIETY FOR QUALITY (ASQ)
ASQ Z1.4
Sampling Procedures and Tables for Inspection by Attributes
(Copies of this document are available from www.asq.org or the American Society for Quality, 611 East
Wisconsin Avenue, Milwaukee, WI 53202.)
ASTM INTERNATIONAL
ASTM A108
Standard Specification for Steel Bar, Carbon and Alloy, Cold-Finished
ASTM B36/B36M
Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
ASTM B134/B134M
Standard Specification for Brass Wire
ASTM B209
Standard Specification for Aluminum and Aluminum-Alloy Sheet and Plate
(Copies of these documents are available from www.astm.org or the ASTM International, 100 Barr Harbor Drive,
West Conshohocken, PA 19428-2959.)
MASTER PAINTERS INSTITUTE (MPI)
MPI Reference # 47
Interior Alkyd, Semi-gloss, MPI Gloss Level 5
(Copies of this document are available from https://www.mpi.net .)
SOCIETY FOR PROTECTIVE COATINGS (SSPC)
SSPC PAINT 25
Zinc Oxide, Alkyd, Linseed Oil Primer for Use Over Hand Cleaned Steel Type I
and Type II
(Copies of this document are available from https://www.sspc.org or the Society for Protective Coatings, 40 24th
Street, 6th Floor, Pittsburgh, PA 15222-4656.)
3. REQUIREMENTS
3.1 Preproduction sample. When specified (see 6.2), before production is commenced, a sample of the item
covered by this specification shall be submitted or made available to the contracting officer or his authorized
representative for approval. The approval of the preproduction sample authorizes the commencement of
production, but does not relieve the supplier of responsibility for compliance with all applicable provisions of this
specification. The preproduction sample shall be manufactured in the same facilities to be used for the
manufacture of the production item.
3.2 Materials. Materials not definitely specified shall be of the quality currently used for the purpose in
commercial practice.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business