MIL-DTL-1407D
3.2.1 Brass wire. Brass wire shall conform to ASTM B134/B134M, UNS C26000, spring temper.
3.2.2 Brass sheet and strip. Brass sheet and strip shall conform to ASTM B36/B36M, annealed temper.
3.2.3 Carbon steel. Cold rolled commercial quality carbon steel in the steel numbers specified in the drawings
shall conform to ASTM A108 for steel bar and QQ-S-698 for steel sheet.
3.2.4 Aluminum sheet. Aluminum sheet shall conform to ASTM B209.
3.2.5 Primer. Primer shall conform to SSPC PAINT 25.
3.2.6 Enamel. Enamel shall conform to MPI Reference # 47. Olive drab color No. 24084 conforming to FED-
STD-595.
3.3 Components. The laundry marking pin set (see 6.2) shall consist of 8 carrier cases. Each carrier case
shall contain 24 trays and, in addition, 50 plain pins. Each tray shall contain 20 numbered pins.
3.3.1 Component identification.
3.3.1.1 Carrier case. Each carrier case shall be marked to identify the 24 trays it contains with an identifying
letter and numbered from 1 to 24 in accordance with table I and as shown on Drawing 5-7-30.
TABLE I. Identification numbering for carrier cases.
Carriers Cases
Identification Numbering
Case A
A1 - A24
Case B
B1 - B24
Case C
C1 - C24
Case D
D1 - D24
Case E
E1 - E24
Case F
F1 - F24
Case G
G1 - G24
Case H
H1 - H24
3.3.1.2 Tray. Each of the 24 trays in a carrier case shall be marked with an identification number consisting of
the carrier case letter and a number from the series 1 through 24.
3.3.1.3 Numbered pins. Each of the 20 pins in a tray shall have the same identification number as the tray.
3.3.1.4 Plain pins. The plain pins shall have no identification number.
3.4 Design.
3.4.1 Carrier case and tray. The design of the carrier case and tray shall be as shown on Drawing 5-7-30.
3.4.2 Numbered and plain pins. The design of the numbered and plain pins shall be as shown on Drawing 5-7-
31. At the option of the supplier, numbered and plain pins of an alternate design shall be acceptable, provided
the pins are interchangeable with the pins shown on Drawing 5-7-31 to the extent that the pins fit into the tray and
the tray filled with pins into the carrier case.
3.5 Construction. The construction of all components shall conform to the requirements herein and as shown
on Drawings 5-7-30 and 5-7-31.
3.5.1 Carrier case assembly.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business